#
# Copyright (C) 2007-2010, 2011-2012 Synopsys, Inc. (www.synopsys.com)
#
# This program is free software; you can redistribute it and/or modify
# it under the terms of the GNU General Public License version 2 as
# published by the Free Software Foundation.
#

menuconfig ARC_PLAT_FPGA_LEGACY
	bool "\"Legacy\" ARC FPGA dev Boards"
	select ISS_SMP_EXTN if SMP
	help
	  Support for ARC development boards, provided by Synopsys.
	  These are based on FPGA or ISS. e.g.
	  - ARCAngel4
	  - ML509
	  - MetaWare ISS

if ARC_PLAT_FPGA_LEGACY

config ARC_BOARD_ANGEL4
	bool "ARC Angel4"
	default y
	help
	  ARC Angel4 FPGA Ref Platform (Xilinx Virtex Based)

config ARC_BOARD_ML509
	bool "ML509"
	help
	  ARC ML509 FPGA Ref Platform (Xilinx Virtex-5 Based)

config ISS_SMP_EXTN
	bool "ARC SMP Extensions (ISS Models only)"
	default n
	depends on SMP
	help
	  SMP Extensions to ARC700, in a "simulation only" Model, supported in
	  ARC ISS (Instruction Set Simulator).
	  The SMP extensions include:
	  -IDU (Interrupt Distribution Unit)
	  -XTL (To enable CPU start/stop/set-PC for another CPU)
	  It doesn't provide coherent Caches and/or Atomic Ops (LLOCK/SCOND)

config ARC_SERIAL_BAUD
	int "UART Baud rate"
	default "115200"
	depends on SERIAL_ARC || SERIAL_ARC_CONSOLE
	help
	  Baud rate for the ARC UART

menuconfig ARC_HAS_BVCI_LAT_UNIT
	bool "BVCI Bus Latency Unit"
	depends on ARC_BOARD_ML509 || ARC_BOARD_ANGEL4
	help
	  IP to add artificial latency to BVCI Bus Based FPGA builds.
	  The default latency (even worst case) for FPGA is non-realistic
	  (~10 SDRAM, ~5 SSRAM).

config BVCI_LAT_UNITS
	hex "Latency Unit(s) Bitmap"
	default "0x0"
	depends on ARC_HAS_BVCI_LAT_UNIT
	help
	  There are multiple Latency Units corresponding to the many
	  interfaces of the system bus arbiter (both CPU side as well as
	  the peripheral side).
	  To add latency to ALL memory transaction, choose Unit 0, otherwise
	  for finer grainer - interface wise latency, specify a bitmap (1 bit
	  per unit) of all units. e.g. 1,2,12 will be 0x1003

	  Unit  0 - System Arb and Mem Controller
	  Unit  1 - I$ and System Bus
	  Unit  2 - D$ and System Bus
	  ..
	  Unit 12 - IDE Disk controller and System Bus

config BVCI_LAT_CYCLES
	int "Latency Value in cycles"
	range 0 63
	default "30"
	depends on ARC_HAS_BVCI_LAT_UNIT

endif