isp1760-hcd.h
5.85 KB
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
#ifndef _ISP1760_HCD_H_
#define _ISP1760_HCD_H_
/* exports for if */
struct usb_hcd *isp1760_register(phys_addr_t res_start, resource_size_t res_len,
int irq, unsigned long irqflags,
int rst_gpio,
struct device *dev, const char *busname,
unsigned int devflags);
int init_kmem_once(void);
void deinit_kmem_cache(void);
/* EHCI capability registers */
#define HC_CAPLENGTH 0x00
#define HC_HCSPARAMS 0x04
#define HC_HCCPARAMS 0x08
/* EHCI operational registers */
#define HC_USBCMD 0x20
#define HC_USBSTS 0x24
#define HC_FRINDEX 0x2c
#define HC_CONFIGFLAG 0x60
#define HC_PORTSC1 0x64
#define HC_ISO_PTD_DONEMAP_REG 0x130
#define HC_ISO_PTD_SKIPMAP_REG 0x134
#define HC_ISO_PTD_LASTPTD_REG 0x138
#define HC_INT_PTD_DONEMAP_REG 0x140
#define HC_INT_PTD_SKIPMAP_REG 0x144
#define HC_INT_PTD_LASTPTD_REG 0x148
#define HC_ATL_PTD_DONEMAP_REG 0x150
#define HC_ATL_PTD_SKIPMAP_REG 0x154
#define HC_ATL_PTD_LASTPTD_REG 0x158
/* Configuration Register */
#define HC_HW_MODE_CTRL 0x300
#define ALL_ATX_RESET (1 << 31)
#define HW_ANA_DIGI_OC (1 << 15)
#define HW_DATA_BUS_32BIT (1 << 8)
#define HW_DACK_POL_HIGH (1 << 6)
#define HW_DREQ_POL_HIGH (1 << 5)
#define HW_INTR_HIGH_ACT (1 << 2)
#define HW_INTR_EDGE_TRIG (1 << 1)
#define HW_GLOBAL_INTR_EN (1 << 0)
#define HC_CHIP_ID_REG 0x304
#define HC_SCRATCH_REG 0x308
#define HC_RESET_REG 0x30c
#define SW_RESET_RESET_HC (1 << 1)
#define SW_RESET_RESET_ALL (1 << 0)
#define HC_BUFFER_STATUS_REG 0x334
#define ISO_BUF_FILL (1 << 2)
#define INT_BUF_FILL (1 << 1)
#define ATL_BUF_FILL (1 << 0)
#define HC_MEMORY_REG 0x33c
#define ISP_BANK(x) ((x) << 16)
#define HC_PORT1_CTRL 0x374
#define PORT1_POWER (3 << 3)
#define PORT1_INIT1 (1 << 7)
#define PORT1_INIT2 (1 << 23)
#define HW_OTG_CTRL_SET 0x374
#define HW_OTG_CTRL_CLR 0x376
/* Interrupt Register */
#define HC_INTERRUPT_REG 0x310
#define HC_INTERRUPT_ENABLE 0x314
#define HC_ISO_INT (1 << 9)
#define HC_ATL_INT (1 << 8)
#define HC_INTL_INT (1 << 7)
#define HC_EOT_INT (1 << 3)
#define HC_SOT_INT (1 << 1)
#define INTERRUPT_ENABLE_MASK (HC_INTL_INT | HC_ATL_INT)
#define HC_ISO_IRQ_MASK_OR_REG 0x318
#define HC_INT_IRQ_MASK_OR_REG 0x31C
#define HC_ATL_IRQ_MASK_OR_REG 0x320
#define HC_ISO_IRQ_MASK_AND_REG 0x324
#define HC_INT_IRQ_MASK_AND_REG 0x328
#define HC_ATL_IRQ_MASK_AND_REG 0x32C
/* urb state*/
#define DELETE_URB (0x0008)
#define NO_TRANSFER_ACTIVE (0xffffffff)
/* Philips Proprietary Transfer Descriptor (PTD) */
typedef __u32 __bitwise __dw;
struct ptd {
__dw dw0;
__dw dw1;
__dw dw2;
__dw dw3;
__dw dw4;
__dw dw5;
__dw dw6;
__dw dw7;
};
#define PTD_OFFSET 0x0400
#define ISO_PTD_OFFSET 0x0400
#define INT_PTD_OFFSET 0x0800
#define ATL_PTD_OFFSET 0x0c00
#define PAYLOAD_OFFSET 0x1000
struct slotinfo {
struct isp1760_qh *qh;
struct isp1760_qtd *qtd;
unsigned long timestamp;
};
typedef void (packet_enqueue)(struct usb_hcd *hcd, struct isp1760_qh *qh,
struct isp1760_qtd *qtd);
/*
* Device flags that can vary from board to board. All of these
* indicate the most "atypical" case, so that a devflags of 0 is
* a sane default configuration.
*/
#define ISP1760_FLAG_BUS_WIDTH_16 0x00000002 /* 16-bit data bus width */
#define ISP1760_FLAG_OTG_EN 0x00000004 /* Port 1 supports OTG */
#define ISP1760_FLAG_ANALOG_OC 0x00000008 /* Analog overcurrent */
#define ISP1760_FLAG_DACK_POL_HIGH 0x00000010 /* DACK active high */
#define ISP1760_FLAG_DREQ_POL_HIGH 0x00000020 /* DREQ active high */
#define ISP1760_FLAG_ISP1761 0x00000040 /* Chip is ISP1761 */
#define ISP1760_FLAG_INTR_POL_HIGH 0x00000080 /* Interrupt polarity active high */
#define ISP1760_FLAG_INTR_EDGE_TRIG 0x00000100 /* Interrupt edge triggered */
#define ISP1760_FLAG_RESET_ACTIVE_HIGH 0x80000000 /* RESET GPIO active high */
/* chip memory management */
struct memory_chunk {
unsigned int start;
unsigned int size;
unsigned int free;
};
/*
* 60kb divided in:
* - 32 blocks @ 256 bytes
* - 20 blocks @ 1024 bytes
* - 4 blocks @ 8192 bytes
*/
#define BLOCK_1_NUM 32
#define BLOCK_2_NUM 20
#define BLOCK_3_NUM 4
#define BLOCK_1_SIZE 256
#define BLOCK_2_SIZE 1024
#define BLOCK_3_SIZE 8192
#define BLOCKS (BLOCK_1_NUM + BLOCK_2_NUM + BLOCK_3_NUM)
#define MAX_PAYLOAD_SIZE BLOCK_3_SIZE
#define PAYLOAD_AREA_SIZE 0xf000
/* ATL */
/* DW0 */
#define DW0_VALID_BIT 1
#define FROM_DW0_VALID(x) ((x) & 0x01)
#define TO_DW0_LENGTH(x) (((u32) x) << 3)
#define TO_DW0_MAXPACKET(x) (((u32) x) << 18)
#define TO_DW0_MULTI(x) (((u32) x) << 29)
#define TO_DW0_ENDPOINT(x) (((u32) x) << 31)
/* DW1 */
#define TO_DW1_DEVICE_ADDR(x) (((u32) x) << 3)
#define TO_DW1_PID_TOKEN(x) (((u32) x) << 10)
#define DW1_TRANS_BULK ((u32) 2 << 12)
#define DW1_TRANS_INT ((u32) 3 << 12)
#define DW1_TRANS_SPLIT ((u32) 1 << 14)
#define DW1_SE_USB_LOSPEED ((u32) 2 << 16)
#define TO_DW1_PORT_NUM(x) (((u32) x) << 18)
#define TO_DW1_HUB_NUM(x) (((u32) x) << 25)
/* DW2 */
#define TO_DW2_DATA_START_ADDR(x) (((u32) x) << 8)
#define TO_DW2_RL(x) ((x) << 25)
#define FROM_DW2_RL(x) (((x) >> 25) & 0xf)
/* DW3 */
#define FROM_DW3_NRBYTESTRANSFERRED(x) ((x) & 0x7fff)
#define FROM_DW3_SCS_NRBYTESTRANSFERRED(x) ((x) & 0x07ff)
#define TO_DW3_NAKCOUNT(x) ((x) << 19)
#define FROM_DW3_NAKCOUNT(x) (((x) >> 19) & 0xf)
#define TO_DW3_CERR(x) ((x) << 23)
#define FROM_DW3_CERR(x) (((x) >> 23) & 0x3)
#define TO_DW3_DATA_TOGGLE(x) ((x) << 25)
#define FROM_DW3_DATA_TOGGLE(x) (((x) >> 25) & 0x1)
#define TO_DW3_PING(x) ((x) << 26)
#define FROM_DW3_PING(x) (((x) >> 26) & 0x1)
#define DW3_ERROR_BIT (1 << 28)
#define DW3_BABBLE_BIT (1 << 29)
#define DW3_HALT_BIT (1 << 30)
#define DW3_ACTIVE_BIT (1 << 31)
#define FROM_DW3_ACTIVE(x) (((x) >> 31) & 0x01)
#define INT_UNDERRUN (1 << 2)
#define INT_BABBLE (1 << 1)
#define INT_EXACT (1 << 0)
#define SETUP_PID (2)
#define IN_PID (1)
#define OUT_PID (0)
/* Errata 1 */
#define RL_COUNTER (0)
#define NAK_COUNTER (0)
#define ERR_COUNTER (2)
#endif /* _ISP1760_HCD_H_ */