5113f6f70
 김현기
kernel add
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
|
/*
* gpio-regulator.h
*
* Copyright 2011 Heiko Stuebner <heiko@sntech.de>
*
* based on fixed.h
*
* Copyright 2008 Wolfson Microelectronics PLC.
*
* Author: Mark Brown <broonie@opensource.wolfsonmicro.com>
*
* Copyright (c) 2009 Nokia Corporation
* Roger Quadros <ext-roger.quadros@nokia.com>
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License as
* published by the Free Software Foundation; either version 2 of the
* License, or (at your option) any later version.
*/
#ifndef __REGULATOR_GPIO_H
#define __REGULATOR_GPIO_H
struct regulator_init_data;
enum regulator_type;
/**
* struct gpio_regulator_state - state description
* @value: microvolts or microamps
* @gpios: bitfield of gpio target-states for the value
*
* This structure describes a supported setting of the regulator
* and the necessary gpio-state to achieve it.
*
* The n-th bit in the bitfield describes the state of the n-th GPIO
* from the gpios-array defined in gpio_regulator_config below.
*/
struct gpio_regulator_state {
int value;
int gpios;
};
/**
* struct gpio_regulator_config - config structure
* @supply_name: Name of the regulator supply
* @enable_gpio: GPIO to use for enable control
* set to -EINVAL if not used
* @enable_high: Polarity of enable GPIO
* 1 = Active high, 0 = Active low
* @enabled_at_boot: Whether regulator has been enabled at
* boot or not. 1 = Yes, 0 = No
* This is used to keep the regulator at
* the default state
* @startup_delay: Start-up time in microseconds
* @gpios: Array containing the gpios needed to control
* the setting of the regulator
* @nr_gpios: Number of gpios
* @states: Array of gpio_regulator_state entries describing
* the gpio state for specific voltages
* @nr_states: Number of states available
* @regulator_type: either REGULATOR_CURRENT or REGULATOR_VOLTAGE
* @init_data: regulator_init_data
*
* This structure contains gpio-voltage regulator configuration
* information that must be passed by platform code to the
* gpio-voltage regulator driver.
*/
struct gpio_regulator_config {
const char *supply_name;
int enable_gpio;
unsigned enable_high:1;
unsigned enabled_at_boot:1;
unsigned startup_delay;
struct gpio *gpios;
int nr_gpios;
struct gpio_regulator_state *states;
int nr_states;
enum regulator_type type;
struct regulator_init_data *init_data;
};
#endif
|