5113f6f70
 김현기
kernel add
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
|
/*
* wanXL serial card driver for Linux
* definitions common to host driver and card firmware
*
* Copyright (C) 2003 Krzysztof Halasa <khc@pm.waw.pl>
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of version 2 of the GNU General Public License
* as published by the Free Software Foundation.
*/
#define RESET_WHILE_LOADING 0
/* you must rebuild the firmware if any of the following is changed */
#define DETECT_RAM 0 /* needed for > 4MB RAM, 16 MB maximum */
#define QUICC_MEMCPY_USES_PLX 1 /* must be used if the host has > 256 MB RAM */
#define STATUS_CABLE_V35 2
#define STATUS_CABLE_X21 3
#define STATUS_CABLE_V24 4
#define STATUS_CABLE_EIA530 5
#define STATUS_CABLE_INVALID 6
#define STATUS_CABLE_NONE 7
#define STATUS_CABLE_DCE 0x8000
#define STATUS_CABLE_DSR 0x0010
#define STATUS_CABLE_DCD 0x0008
#define STATUS_CABLE_PM_SHIFT 5
#define PDM_OFFSET 0x1000
#define TX_BUFFERS 10 /* per port */
#define RX_BUFFERS 30
#define RX_QUEUE_LENGTH 40 /* card->host queue length - per card */
#define PACKET_EMPTY 0x00
#define PACKET_FULL 0x10
#define PACKET_SENT 0x20 /* TX only */
#define PACKET_UNDERRUN 0x30 /* TX only */
#define PACKET_PORT_MASK 0x03 /* RX only */
/* bit numbers in PLX9060 doorbell registers */
#define DOORBELL_FROM_CARD_TX_0 0 /* packet sent by the card */
#define DOORBELL_FROM_CARD_TX_1 1
#define DOORBELL_FROM_CARD_TX_2 2
#define DOORBELL_FROM_CARD_TX_3 3
#define DOORBELL_FROM_CARD_RX 4
#define DOORBELL_FROM_CARD_CABLE_0 5 /* cable/PM/etc. changed */
#define DOORBELL_FROM_CARD_CABLE_1 6
#define DOORBELL_FROM_CARD_CABLE_2 7
#define DOORBELL_FROM_CARD_CABLE_3 8
#define DOORBELL_TO_CARD_OPEN_0 0
#define DOORBELL_TO_CARD_OPEN_1 1
#define DOORBELL_TO_CARD_OPEN_2 2
#define DOORBELL_TO_CARD_OPEN_3 3
#define DOORBELL_TO_CARD_CLOSE_0 4
#define DOORBELL_TO_CARD_CLOSE_1 5
#define DOORBELL_TO_CARD_CLOSE_2 6
#define DOORBELL_TO_CARD_CLOSE_3 7
#define DOORBELL_TO_CARD_TX_0 8 /* outbound packet queued */
#define DOORBELL_TO_CARD_TX_1 9
#define DOORBELL_TO_CARD_TX_2 10
#define DOORBELL_TO_CARD_TX_3 11
/* firmware-only status bits, starting from last DOORBELL_TO_CARD + 1 */
#define TASK_SCC_0 12
#define TASK_SCC_1 13
#define TASK_SCC_2 14
#define TASK_SCC_3 15
#define ALIGN32(x) (((x) + 3) & 0xFFFFFFFC)
#define BUFFER_LENGTH ALIGN32(HDLC_MAX_MRU + 4) /* 4 bytes for 32-bit CRC */
/* Address of TX and RX buffers in 68360 address space */
#define BUFFERS_ADDR 0x4000 /* 16 KB */
#ifndef __ASSEMBLER__
#define PLX_OFFSET 0
#else
#define PLX_OFFSET PLX + 0x80
#endif
#define PLX_MAILBOX_0 (PLX_OFFSET + 0x40)
#define PLX_MAILBOX_1 (PLX_OFFSET + 0x44)
#define PLX_MAILBOX_2 (PLX_OFFSET + 0x48)
#define PLX_MAILBOX_3 (PLX_OFFSET + 0x4C)
#define PLX_MAILBOX_4 (PLX_OFFSET + 0x50)
#define PLX_MAILBOX_5 (PLX_OFFSET + 0x54)
#define PLX_MAILBOX_6 (PLX_OFFSET + 0x58)
#define PLX_MAILBOX_7 (PLX_OFFSET + 0x5C)
#define PLX_DOORBELL_TO_CARD (PLX_OFFSET + 0x60)
#define PLX_DOORBELL_FROM_CARD (PLX_OFFSET + 0x64)
#define PLX_INTERRUPT_CS (PLX_OFFSET + 0x68)
#define PLX_CONTROL (PLX_OFFSET + 0x6C)
#ifdef __ASSEMBLER__
#define PLX_DMA_0_MODE (PLX + 0x100)
#define PLX_DMA_0_PCI (PLX + 0x104)
#define PLX_DMA_0_LOCAL (PLX + 0x108)
#define PLX_DMA_0_LENGTH (PLX + 0x10C)
#define PLX_DMA_0_DESC (PLX + 0x110)
#define PLX_DMA_1_MODE (PLX + 0x114)
#define PLX_DMA_1_PCI (PLX + 0x118)
#define PLX_DMA_1_LOCAL (PLX + 0x11C)
#define PLX_DMA_1_LENGTH (PLX + 0x120)
#define PLX_DMA_1_DESC (PLX + 0x124)
#define PLX_DMA_CMD_STS (PLX + 0x128)
#define PLX_DMA_ARBITR_0 (PLX + 0x12C)
#define PLX_DMA_ARBITR_1 (PLX + 0x130)
#endif
#define DESC_LENGTH 12
/* offsets from start of status_t */
/* card to host */
#define STATUS_OPEN 0
#define STATUS_CABLE (STATUS_OPEN + 4)
#define STATUS_RX_OVERRUNS (STATUS_CABLE + 4)
#define STATUS_RX_FRAME_ERRORS (STATUS_RX_OVERRUNS + 4)
/* host to card */
#define STATUS_PARITY (STATUS_RX_FRAME_ERRORS + 4)
#define STATUS_ENCODING (STATUS_PARITY + 4)
#define STATUS_CLOCKING (STATUS_ENCODING + 4)
#define STATUS_TX_DESCS (STATUS_CLOCKING + 4)
#ifndef __ASSEMBLER__
typedef struct {
volatile u32 stat;
u32 address; /* PCI address */
volatile u32 length;
}desc_t;
typedef struct {
// Card to host
volatile u32 open;
volatile u32 cable;
volatile u32 rx_overruns;
volatile u32 rx_frame_errors;
// Host to card
u32 parity;
u32 encoding;
u32 clocking;
desc_t tx_descs[TX_BUFFERS];
}port_status_t;
#endif /* __ASSEMBLER__ */
|