6b13f685e
 김민수
BSP 최초 추가
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
|
/*
* Configuation settings for the Renesas R7780MP board
*
* Copyright (C) 2007,2008 Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
* Copyright (C) 2008 Yusuke Goda <goda.yusuke@renesas.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __R7780RP_H
#define __R7780RP_H
#undef DEBUG
#define CONFIG_CPU_SH7780 1
#define CONFIG_R7780MP 1
#define CONFIG_SYS_R7780MP_OLD_FLASH 1
#define __LITTLE_ENDIAN__ 1
/*
* Command line configuration.
*/
#define CONFIG_CMD_SDRAM
#define CONFIG_CMD_FLASH
#define CONFIG_CMD_MEMORY
#define CONFIG_CMD_PCI
#define CONFIG_CMD_NET
#define CONFIG_CMD_PING
#define CONFIG_CMD_SAVEENV
#define CONFIG_CMD_NFS
#define CONFIG_CMD_IDE
#define CONFIG_CMD_EXT2
#define CONFIG_DOS_PARTITION
#define CONFIG_SCIF_CONSOLE 1
#define CONFIG_BAUDRATE 115200
#define CONFIG_CONS_SCIF0 1
#define CONFIG_BOOTDELAY 3
#define CONFIG_BOOTARGS "console=ttySC0,115200"
#define CONFIG_ENV_OVERWRITE 1
/* check for keypress on bootdelay==0 */
/*#define CONFIG_ZERO_BOOTDELAY_CHECK*/
#define CONFIG_SYS_TEXT_BASE 0x0FFC0000
#define CONFIG_SYS_SDRAM_BASE (0x08000000)
#define CONFIG_SYS_SDRAM_SIZE (128 * 1024 * 1024)
#define CONFIG_SYS_LONGHELP
#define CONFIG_SYS_CBSIZE 256
#define CONFIG_SYS_PBSIZE 256
#define CONFIG_SYS_MAXARGS 16
#define CONFIG_SYS_BARGSIZE 512
#define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE)
#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_TEXT_BASE - 0x100000)
/* Flash board support */
#define CONFIG_SYS_FLASH_BASE (0xA0000000)
#ifdef CONFIG_SYS_R7780MP_OLD_FLASH
/* NOR Flash (S29PL127J60TFI130) */
# define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_32BIT
# define CONFIG_SYS_MAX_FLASH_BANKS (2)
# define CONFIG_SYS_MAX_FLASH_SECT 270
# define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE,\
CONFIG_SYS_FLASH_BASE + 0x100000,\
CONFIG_SYS_FLASH_BASE + 0x400000,\
CONFIG_SYS_FLASH_BASE + 0x700000, }
#else /* CONFIG_SYS_R7780MP_OLD_FLASH */
/* NOR Flash (Spantion S29GL256P) */
# define CONFIG_SYS_MAX_FLASH_BANKS (1)
# define CONFIG_SYS_MAX_FLASH_SECT 256
# define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE }
#endif /* CONFIG_SYS_R7780MP_OLD_FLASH */
#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 4 * 1024 * 1024)
/* Address of u-boot image in Flash */
#define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE)
#define CONFIG_SYS_MONITOR_LEN (256 * 1024)
/* Size of DRAM reserved for malloc() use */
#define CONFIG_SYS_MALLOC_LEN (1204 * 1024)
#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024)
#define CONFIG_SYS_RX_ETH_BUFFER (8)
#define CONFIG_SYS_FLASH_CFI
#define CONFIG_FLASH_CFI_DRIVER
#undef CONFIG_SYS_FLASH_CFI_BROKEN_TABLE
#undef CONFIG_SYS_FLASH_QUIET_TEST
/* print 'E' for empty sector on flinfo */
#define CONFIG_SYS_FLASH_EMPTY_INFO
#define CONFIG_ENV_IS_IN_FLASH
#define CONFIG_ENV_SECT_SIZE (256 * 1024)
#define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE)
#define CONFIG_ENV_ADDR (CONFIG_SYS_MONITOR_BASE + CONFIG_SYS_MONITOR_LEN)
#define CONFIG_SYS_FLASH_ERASE_TOUT 120000
#define CONFIG_SYS_FLASH_WRITE_TOUT 500
/* Board Clock */
#define CONFIG_SYS_CLK_FREQ 33333333
#define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ
#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ
#define CONFIG_SYS_TMU_CLK_DIV 4
/* PCI Controller */
#if defined(CONFIG_CMD_PCI)
#define CONFIG_PCI
#define CONFIG_SH4_PCI
#define CONFIG_SH7780_PCI
#define CONFIG_SH7780_PCI_LSR 0x07f00001
#define CONFIG_SH7780_PCI_LAR CONFIG_SYS_SDRAM_SIZE
#define CONFIG_SH7780_PCI_BAR CONFIG_SYS_SDRAM_SIZE
#define CONFIG_PCI_PNP
#define CONFIG_PCI_SCAN_SHOW 1
#define __io
#define __mem_pci
#define CONFIG_PCI_MEM_BUS 0xFD000000 /* Memory space base addr */
#define CONFIG_PCI_MEM_PHYS CONFIG_PCI_MEM_BUS
#define CONFIG_PCI_MEM_SIZE 0x01000000 /* Size of Memory window */
#define CONFIG_PCI_IO_BUS 0xFE200000 /* IO space base address */
#define CONFIG_PCI_IO_PHYS CONFIG_PCI_IO_BUS
#define CONFIG_PCI_IO_SIZE 0x00200000 /* Size of IO window */
#define CONFIG_PCI_SYS_PHYS CONFIG_SYS_SDRAM_BASE
#define CONFIG_PCI_SYS_BUS CONFIG_SYS_SDRAM_BASE
#define CONFIG_PCI_SYS_SIZE CONFIG_SYS_SDRAM_SIZE
#endif /* CONFIG_CMD_PCI */
#if defined(CONFIG_CMD_NET)
/*
#define CONFIG_RTL8169
*/
/* AX88796L Support(NE2000 base chip) */
#define CONFIG_DRIVER_AX88796L
#define CONFIG_DRIVER_NE2000_BASE 0xA4100000
#endif
/* Compact flash Support */
#if defined(CONFIG_CMD_IDE)
#define CONFIG_IDE_RESET 1
#define CONFIG_SYS_PIO_MODE 1
#define CONFIG_SYS_IDE_MAXBUS 1 /* IDE bus */
#define CONFIG_SYS_IDE_MAXDEVICE 1
#define CONFIG_SYS_ATA_BASE_ADDR 0xb4000000
#define CONFIG_SYS_ATA_STRIDE 2 /* 1bit shift */
#define CONFIG_SYS_ATA_DATA_OFFSET 0x1000 /* data reg offset */
#define CONFIG_SYS_ATA_REG_OFFSET 0x1000 /* reg offset */
#define CONFIG_SYS_ATA_ALT_OFFSET 0x800 /* alternate register offset */
#define CONFIG_IDE_SWAP_IO
#endif /* CONFIG_CMD_IDE */
#endif /* __R7780RP_H */
|