에프에이리눅스 / 1611_0007_prime_oven

Blame view

bootloader/u-boot_2015_04/board/socrates/tlb.c 3.32 KB
edit raw normal view history
6b13f685e   김민수   BSP 최초 추가 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
 
  /*
   * (C) Copyright 2008
   * Sergei Poselenov, Emcraft Systems, sposelenov@emcraft.com.
   *
   * Copyright 2008 Freescale Semiconductor, Inc.
   *
   * (C) Copyright 2000
   * Wolfgang Denk, DENX Software Engineering, wd@denx.de.
   *
   * SPDX-License-Identifier:	GPL-2.0+
   */
  
  #include <common.h>
  #include <asm/mmu.h>
  
  struct fsl_e_tlb_entry tlb_table[] = {
  	/* TLB 0 - for temp stack in cache */
  	SET_TLB_ENTRY(0, CONFIG_SYS_INIT_RAM_ADDR, CONFIG_SYS_INIT_RAM_ADDR,
  		      MAS3_SX|MAS3_SW|MAS3_SR, 0,
  		      0, 0, BOOKE_PAGESZ_4K, 0),
  	SET_TLB_ENTRY(0, CONFIG_SYS_INIT_RAM_ADDR + 4 * 1024 , CONFIG_SYS_INIT_RAM_ADDR + 4 * 1024,
  		      MAS3_SX|MAS3_SW|MAS3_SR, 0,
  		      0, 0, BOOKE_PAGESZ_4K, 0),
  	SET_TLB_ENTRY(0, CONFIG_SYS_INIT_RAM_ADDR + 8 * 1024 , CONFIG_SYS_INIT_RAM_ADDR + 8 * 1024,
  		      MAS3_SX|MAS3_SW|MAS3_SR, 0,
  		      0, 0, BOOKE_PAGESZ_4K, 0),
  	SET_TLB_ENTRY(0, CONFIG_SYS_INIT_RAM_ADDR + 12 * 1024 , CONFIG_SYS_INIT_RAM_ADDR + 12 * 1024,
  		      MAS3_SX|MAS3_SW|MAS3_SR, 0,
  		      0, 0, BOOKE_PAGESZ_4K, 0),
  
  
  	/*
  	 * TLB 1:	64M	Non-cacheable, guarded
  	 * 0xfc000000	64M	FLASH
  	 * Out of reset this entry is only 4K.
  	 */
  	SET_TLB_ENTRY(1, CONFIG_SYS_FLASH_BASE, CONFIG_SYS_FLASH_BASE,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 1, BOOKE_PAGESZ_64M, 1),
  
  	/*
  	 * TLB 2:	256M	Non-cacheable, guarded
  	 * 0x80000000	256M	PCI1 MEM First half
  	 */
  	SET_TLB_ENTRY(1, CONFIG_SYS_PCI1_MEM_PHYS, CONFIG_SYS_PCI1_MEM_PHYS,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 2, BOOKE_PAGESZ_256M, 1),
  
  	/*
  	 * TLB 3:	256M	Non-cacheable, guarded
  	 * 0x90000000	256M	PCI1 MEM Second half
  	 */
  	SET_TLB_ENTRY(1, CONFIG_SYS_PCI1_MEM_PHYS + 0x10000000, CONFIG_SYS_PCI1_MEM_PHYS + 0x10000000,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 3, BOOKE_PAGESZ_256M, 1),
  
  #if defined(CONFIG_SYS_FPGA_BASE)
  	/*
  	 * TLB 4:	1M	Non-cacheable, guarded
  	 * 0xc0000000	1M	FPGA and NAND
  	 */
  	SET_TLB_ENTRY(1, CONFIG_SYS_FPGA_BASE, CONFIG_SYS_FPGA_BASE,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 4, BOOKE_PAGESZ_1M, 1),
  #endif
  
  	/*
  	 * TLB 5:	64M	Non-cacheable, guarded
  	 * 0xc8000000	16M	LIME GDC framebuffer
  	 * 0xc9fc0000	256K	LIME GDC MMIO
  	 * (0xcbfc0000	256K	LIME GDC MMIO)
  	 * MMIO is relocatable and could be at 0xcbfc0000
  	 */
  	SET_TLB_ENTRY(1, CONFIG_SYS_LIME_BASE, CONFIG_SYS_LIME_BASE,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 5, BOOKE_PAGESZ_64M, 1),
  
  	/*
  	 * TLB 6:	64M	Non-cacheable, guarded
  	 * 0xe000_0000	1M	CCSRBAR
  	 * 0xe200_0000	16M	PCI1 IO
  	 */
  	SET_TLB_ENTRY(1, CONFIG_SYS_CCSRBAR, CONFIG_SYS_CCSRBAR_PHYS,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 6, BOOKE_PAGESZ_64M, 1),
  
  #if !defined(CONFIG_SPD_EEPROM)
  	/*
  	 * TLB 7+8:	512M	DDR, cache disabled (needed for memory test)
  	 * 0x00000000  512M	DDR System memory
  	 * Without SPD EEPROM configured DDR, this must be setup manually.
  	 * Make sure the TLB count at the top of this table is correct.
  	 * Likely it needs to be increased by two for these entries.
  	 */
  	SET_TLB_ENTRY(1, CONFIG_SYS_DDR_SDRAM_BASE, CONFIG_SYS_DDR_SDRAM_BASE,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 7, BOOKE_PAGESZ_256M, 1),
  
  	SET_TLB_ENTRY(1, CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000, CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000,
  		      MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
  		      0, 8, BOOKE_PAGESZ_256M, 1),
  #endif
  };
  
  int num_tlb_entries = ARRAY_SIZE(tlb_table);