6b13f685e
 김민수
BSP 최초 추가
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
|
/*
* (C) Copyright 2005
* STMicroelectronics.
* Configuration settings for the "Nomadik Hardware Kit" NHK-8815,
* the evaluation board for the Nomadik 8815 System on Chip.
*
* SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __CONFIG_H
#define __CONFIG_H
#include <nomadik.h>
#define CONFIG_NOMADIK_8815 /* cpu variant */
#define CONFIG_SKIP_LOWLEVEL_INIT /* we have already been loaded to RAM */
/* commands */
#include <config_cmd_default.h>
#define CONFIG_CMD_NET
#define CONFIG_CMD_PING
#define CONFIG_CMD_DHCP
#define CONFIG_CMD_NFS
/* There is no NOR flash, so undefine these commands */
#undef CONFIG_CMD_FLASH
#undef CONFIG_CMD_IMLS
#define CONFIG_SYS_NO_FLASH
/* There is NAND storage */
#define CONFIG_NAND_NOMADIK
#define CONFIG_CMD_JFFS2
/* user interface */
#define CONFIG_SYS_LONGHELP
#define CONFIG_SYS_HUSH_PARSER
#define CONFIG_SYS_PROMPT "Nomadik> "
#define CONFIG_CMDLINE_EDITING
#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE \
+ sizeof(CONFIG_SYS_PROMPT) + 16)
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Arg Buffer Size */
#define CONFIG_SYS_MAXARGS 16
#define CONFIG_SYS_LOAD_ADDR 0x800000 /* default load address */
#define CONFIG_SYS_LOADS_BAUD_CHANGE
/* boot config */
#define CONFIG_SETUP_MEMORY_TAGS
#define CONFIG_INITRD_TAG
#define CONFIG_CMDLINE_TAG
#define CONFIG_BOOTDELAY 1
#define CONFIG_BOOTARGS "root=/dev/ram0 console=ttyAMA1,115200n8 init=linuxrc"
#define CONFIG_BOOTCOMMAND "fsload 0x100000 kernel.uimg;" \
" fsload 0x800000 initrd.gz.uimg;" \
" bootm 0x100000 0x800000"
/* memory-related information */
#define CONFIG_NR_DRAM_BANKS 2
#define PHYS_SDRAM_1 0x00000000 /* DDR-SDRAM Bank #1 */
#define PHYS_SDRAM_1_SIZE 0x04000000 /* 64 MB */
#define PHYS_SDRAM_2 0x08000000 /* SDR-SDRAM BANK #2*/
#define PHYS_SDRAM_2_SIZE 0x04000000 /* 64 MB */
#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM_1
#define CONFIG_SYS_SDRAM_SIZE (PHYS_SDRAM_1_SIZE + PHYS_SDRAM_2_SIZE)
/* The IPL loads us at 0, tell so to u-boot. Put stack pointer 1M into RAM */
#define CONFIG_SYS_TEXT_BASE 0x00000000
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_TEXT_BASE + (1<<20))
#define CONFIG_SYS_MEMTEST_START 0x00000000
#define CONFIG_SYS_MEMTEST_END 0x0FFFFFFF
#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 256 * 1024)
#define CONFIG_BOARD_LATE_INIT /* call board_late_init during start up */
/* timing informazion */
#define CONFIG_SYS_TIMERBASE 0x101E2000
/* serial port (PL011) configuration */
#define CONFIG_PL011_SERIAL
#define CONFIG_CONS_INDEX 1
#define CONFIG_BAUDRATE 115200
#define CFG_SERIAL0 0x101FD000
#define CFG_SERIAL1 0x101FB000
#define CONFIG_PL01x_PORTS { (void *)CFG_SERIAL0, (void *)CFG_SERIAL1 }
#define CONFIG_PL011_CLOCK 48000000
/* i2c, for the port extenders (uses gpio.c in board directory) */
#ifndef __ASSEMBLY__
#include <asm/arch/gpio.h>
#define CONFIG_CMD_I2C
#define CONFIG_SYS_I2C
#define CONFIG_SYS_I2C_SOFT 1 /* I2C bit-banged */
#define I2C_SOFT_DEFS
#define CONFIG_SYS_I2C_SOFT_SPEED 400000
#define CONFIG_SYS_I2C_SOFT_SLAVE 0x7F
#define __SDA 63
#define __SCL 62
#define I2C_SDA(x) nmk_gpio_set(__SDA, x)
#define I2C_SCL(x) nmk_gpio_set(__SCL, x)
#define I2C_READ (nmk_gpio_get(__SDA)!=0)
#define I2C_ACTIVE nmk_gpio_dir(__SDA, 1)
#define I2C_TRISTATE nmk_gpio_dir(__SDA, 0)
#define I2C_DELAY (udelay(2))
#endif /* __ASSEMBLY__ */
/* Ethernet */
#define PCI_MEMORY_VADDR 0xe8000000
#define PCI_IO_VADDR 0xee000000
#define __io(a) ((void __iomem *)(PCI_IO_VADDR + (a)))
#define __mem_isa(a) ((a) + PCI_MEMORY_VADDR)
#define CONFIG_SMC91111 /* Using SMC91c111*/
#define CONFIG_SMC91111_BASE 0x34000300
#undef CONFIG_SMC91111_EXT_PHY /* Internal PHY */
#define CONFIG_SMC_USE_32_BIT
#define CONFIG_BOOTFILE "uImage"
#define CONFIG_IP_DEFRAG /* Allows faster download, TFTP and NFS */
#define CONFIG_TFTP_BLOCKSIZE 4096
#define CONFIG_NFS_READ_SIZE 4096
/* Storage information: onenand and nand */
#define CONFIG_CMD_ONENAND
#define CONFIG_MTD_ONENAND_VERIFY_WRITE
#define CONFIG_SYS_ONENAND_BASE 0x30000000
#define CONFIG_CMD_NAND
#define CONFIG_SYS_MAX_NAND_DEVICE 1
#define CONFIG_SYS_NAND_BASE 0x40000000 /* SMPS0n */
/*
* Filesystem information
*
* Since U-Boot has been loaded to RAM by vendor code, we could use
* either or both OneNand and Nand. However, we need to know where the
* filesystem lives. Comments below report vendor-selected partitions
*/
#ifdef CONFIG_BOOT_ONENAND
/* Partition Size Start
* XloaderTOC + X-Loader 256KB 0x00000000
* Memory init function 256KB 0x00040000
* U-Boot + env 2MB 0x00080000
* Sysimage (kernel + ramdisk) 4MB 0x00280000
* JFFS2 Root filesystem 22MB 0x00680000
* JFFS2 User Data 227.5MB 0x01C80000
*/
# define CONFIG_JFFS2_DEV "onenand0"
# define CONFIG_JFFS2_PART_SIZE 0x01600000
# define CONFIG_JFFS2_PART_OFFSET 0x00680000
# define CONFIG_ENV_IS_IN_ONENAND
# define CONFIG_ENV_SIZE 0x20000 /* 128 Kb - one sector */
# define CONFIG_ENV_ADDR (0x00280000 - CONFIG_ENV_SIZE)
#else /* BOOT_NAND */
/* Partition Size Start
* XloaderTOC + X-Loader 256KB 0x00000000
* Memory init function 256KB 0x00040000
* U-Boot + env 2MB 0x00080000
* Kernel Image 3MB 0x00280000
* JFFS2 Root filesystem 22MB 0x00580000
* JFFS2 User Data 100.5MB 0x01b80000
*/
# define CONFIG_JFFS2_DEV "nand0"
# define CONFIG_JFFS2_NAND 1 /* For the jffs2 support*/
# define CONFIG_JFFS2_PART_SIZE 0x01600000
# define CONFIG_JFFS2_PART_OFFSET 0x00580000
# define CONFIG_ENV_IS_IN_NAND
# define CONFIG_ENV_SIZE 0x20000 /* 128 Kb - one sector */
# define CONFIG_ENV_OFFSET (0x00280000 - CONFIG_ENV_SIZE)
#endif /* CONFIG_BOOT_ONENAND */
/* this is needed to make hello_world.c and other stuff happy */
#define CONFIG_SYS_MAX_FLASH_SECT 512
#define CONFIG_SYS_MAX_FLASH_BANKS 1
#endif /* __CONFIG_H */
|