6b13f685e
 김민수
BSP 최초 추가
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
|
/*
* Standard pin control state definitions
*/
/**
* @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put
* into as default, usually this means the pins are up and ready to
* be used by the device driver. This state is commonly used by
* hogs to configure muxing and pins at boot, and also as a state
* to go into when returning from sleep and idle in
* .pm_runtime_resume() or ordinary .resume() for example.
* @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into
* when the pins are idle. This is a state where the system is relaxed
* but not fully sleeping - some power may be on but clocks gated for
* example. Could typically be set from a pm_runtime_suspend() or
* pm_runtime_idle() operation.
* @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into
* when the pins are sleeping. This is a state where the system is in
* its lowest sleep state. Could typically be set from an
* ordinary .suspend() function.
*/
#define PINCTRL_STATE_DEFAULT "default"
#define PINCTRL_STATE_IDLE "idle"
#define PINCTRL_STATE_SLEEP "sleep"
|