6b13f685e
 김민수
BSP 최초 추가
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
|
What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode
Date: March 2010
Contact: Bruno Prémont <bonbons@linux-vserver.org>
Description: Make it possible to switch the PicoLCD device between LCD
(firmware) and bootloader (flasher) operation modes.
Reading: returns list of available modes, the active mode being
enclosed in brackets ('[' and ']')
Writing: causes operation mode switch. Permitted values are
the non-active mode names listed when read.
Note: when switching mode the current PicoLCD HID device gets
disconnected and reconnects after above delay (see attribute
operation_mode_delay for its value).
What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode_delay
Date: April 2010
Contact: Bruno Prémont <bonbons@linux-vserver.org>
Description: Delay PicoLCD waits before restarting in new mode when
operation_mode has changed.
Reading/Writing: It is expressed in ms and permitted range is
0..30000ms.
What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/fb_update_rate
Date: March 2010
Contact: Bruno Prémont <bonbons@linux-vserver.org>
Description: Make it possible to adjust defio refresh rate.
Reading: returns list of available refresh rates (expressed in Hz),
the active refresh rate being enclosed in brackets ('[' and ']')
Writing: accepts new refresh rate expressed in integer Hz
within permitted rates.
Note: As device can barely do 2 complete refreshes a second
it only makes sense to adjust this value if only one or two
tiles get changed and it's not appropriate to expect the application
to flush it's tiny changes explicitely at higher than default rate.
|