6b13f685e
 김민수
BSP 최초 추가
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
308
309
310
311
312
313
314
315
316
317
318
319
320
321
322
323
324
325
326
327
328
329
330
331
332
333
334
335
336
337
338
339
340
341
342
343
344
345
346
347
348
349
350
351
352
353
354
355
356
357
358
359
360
361
362
363
364
365
366
367
368
369
370
371
372
373
374
375
376
|
/*
* (C) Copyright 2000-2003
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#define PHYS_FLASH_1 CONFIG_SYS_FLASH_BASE
#define FLASH_BANK_SIZE 0x200000
flash_info_t flash_info[CONFIG_SYS_MAX_FLASH_BANKS];
void flash_print_info (flash_info_t * info)
{
int i;
switch (info->flash_id & FLASH_VENDMASK) {
case (AMD_MANUFACT & FLASH_VENDMASK):
printf ("AMD: ");
break;
default:
printf ("Unknown Vendor ");
break;
}
switch (info->flash_id & FLASH_TYPEMASK) {
case (AMD_ID_PL160CB & FLASH_TYPEMASK):
printf ("AM29PL160CB (16Mbit)
");
break;
default:
printf ("Unknown Chip Type
");
goto Done;
break;
}
printf (" Size: %ld MB in %d Sectors
",
info->size >> 20, info->sector_count);
printf (" Sector Start Addresses:");
for (i = 0; i < info->sector_count; i++) {
if ((i % 5) == 0) {
printf ("
");
}
printf (" %08lX%s", info->start[i],
info->protect[i] ? " (RO)" : " ");
}
printf ("
");
Done:
return;
}
unsigned long flash_init (void)
{
int i, j;
ulong size = 0;
for (i = 0; i < CONFIG_SYS_MAX_FLASH_BANKS; i++) {
ulong flashbase = 0;
flash_info[i].flash_id =
(AMD_MANUFACT & FLASH_VENDMASK) |
(AMD_ID_PL160CB & FLASH_TYPEMASK);
flash_info[i].size = FLASH_BANK_SIZE;
flash_info[i].sector_count = CONFIG_SYS_MAX_FLASH_SECT;
memset (flash_info[i].protect, 0, CONFIG_SYS_MAX_FLASH_SECT);
if (i == 0)
flashbase = PHYS_FLASH_1;
else
panic ("configured to many flash banks!
");
for (j = 0; j < flash_info[i].sector_count; j++) {
if (j == 0) {
/* 1st is 16 KiB */
flash_info[i].start[j] = flashbase;
}
if ((j >= 1) && (j <= 2)) {
/* 2nd and 3rd are 8 KiB */
flash_info[i].start[j] =
flashbase + 0x4000 + 0x2000 * (j - 1);
}
if (j == 3) {
/* 4th is 224 KiB */
flash_info[i].start[j] = flashbase + 0x8000;
}
if ((j >= 4) && (j <= 10)) {
/* rest is 256 KiB */
flash_info[i].start[j] =
flashbase + 0x40000 + 0x40000 * (j -
4);
}
}
size += flash_info[i].size;
}
flash_protect (FLAG_PROTECT_SET,
CONFIG_SYS_FLASH_BASE,
CONFIG_SYS_FLASH_BASE + 0x3ffff, &flash_info[0]);
return size;
}
#define CMD_READ_ARRAY 0x00F0
#define CMD_UNLOCK1 0x00AA
#define CMD_UNLOCK2 0x0055
#define CMD_ERASE_SETUP 0x0080
#define CMD_ERASE_CONFIRM 0x0030
#define CMD_PROGRAM 0x00A0
#define CMD_UNLOCK_BYPASS 0x0020
#define MEM_FLASH_ADDR1 (*(volatile u16 *)(CONFIG_SYS_FLASH_BASE + (0x00000555<<1)))
#define MEM_FLASH_ADDR2 (*(volatile u16 *)(CONFIG_SYS_FLASH_BASE + (0x000002AA<<1)))
#define BIT_ERASE_DONE 0x0080
#define BIT_RDY_MASK 0x0080
#define BIT_PROGRAM_ERROR 0x0020
#define BIT_TIMEOUT 0x80000000 /* our flag */
#define READY 1
#define ERR 2
#define TMO 4
int flash_erase (flash_info_t * info, int s_first, int s_last)
{
ulong result;
int iflag, cflag, prot, sect;
int rc = ERR_OK;
int chip1;
ulong start;
/* first look for protection bits */
if (info->flash_id == FLASH_UNKNOWN)
return ERR_UNKNOWN_FLASH_TYPE;
if ((s_first < 0) || (s_first > s_last)) {
return ERR_INVAL;
}
if ((info->flash_id & FLASH_VENDMASK) !=
(AMD_MANUFACT & FLASH_VENDMASK)) {
return ERR_UNKNOWN_FLASH_VENDOR;
}
prot = 0;
for (sect = s_first; sect <= s_last; ++sect) {
if (info->protect[sect]) {
prot++;
}
}
if (prot)
return ERR_PROTECTED;
/*
* Disable interrupts which might cause a timeout
* here. Remember that our exception vectors are
* at address 0 in the flash, and we don't want a
* (ticker) exception to happen while the flash
* chip is in programming mode.
*/
cflag = icache_status ();
icache_disable ();
iflag = disable_interrupts ();
printf ("
");
/* Start erase on unprotected sectors */
for (sect = s_first; sect <= s_last && !ctrlc (); sect++) {
printf ("Erasing sector %2d ... ", sect);
/* arm simple, non interrupt dependent timer */
start = get_timer(0);
if (info->protect[sect] == 0) { /* not protected */
volatile u16 *addr =
(volatile u16 *) (info->start[sect]);
MEM_FLASH_ADDR1 = CMD_UNLOCK1;
MEM_FLASH_ADDR2 = CMD_UNLOCK2;
MEM_FLASH_ADDR1 = CMD_ERASE_SETUP;
MEM_FLASH_ADDR1 = CMD_UNLOCK1;
MEM_FLASH_ADDR2 = CMD_UNLOCK2;
*addr = CMD_ERASE_CONFIRM;
/* wait until flash is ready */
chip1 = 0;
do {
result = *addr;
/* check timeout */
if (get_timer(start) > CONFIG_SYS_FLASH_ERASE_TOUT) {
MEM_FLASH_ADDR1 = CMD_READ_ARRAY;
chip1 = TMO;
break;
}
if (!chip1
&& (result & 0xFFFF) & BIT_ERASE_DONE)
chip1 = READY;
} while (!chip1);
MEM_FLASH_ADDR1 = CMD_READ_ARRAY;
if (chip1 == ERR) {
rc = ERR_PROG_ERROR;
goto outahere;
}
if (chip1 == TMO) {
rc = ERR_TIMOUT;
goto outahere;
}
printf ("ok.
");
} else { /* it was protected */
printf ("protected!
");
}
}
if (ctrlc ())
printf ("User Interrupt!
");
outahere:
/* allow flash to settle - wait 10 ms */
udelay (10000);
if (iflag)
enable_interrupts ();
if (cflag)
icache_enable ();
return rc;
}
static int write_word (flash_info_t * info, ulong dest, ulong data)
{
volatile u16 *addr = (volatile u16 *) dest;
ulong result;
int rc = ERR_OK;
int cflag, iflag;
int chip1;
ulong start;
/*
* Check if Flash is (sufficiently) erased
*/
result = *addr;
if ((result & data) != data)
return ERR_NOT_ERASED;
/*
* Disable interrupts which might cause a timeout
* here. Remember that our exception vectors are
* at address 0 in the flash, and we don't want a
* (ticker) exception to happen while the flash
* chip is in programming mode.
*/
cflag = icache_status ();
icache_disable ();
iflag = disable_interrupts ();
MEM_FLASH_ADDR1 = CMD_UNLOCK1;
MEM_FLASH_ADDR2 = CMD_UNLOCK2;
MEM_FLASH_ADDR1 = CMD_PROGRAM;
*addr = data;
/* arm simple, non interrupt dependent timer */
start = get_timer(0);
/* wait until flash is ready */
chip1 = 0;
do {
result = *addr;
/* check timeout */
if (get_timer(start) > CONFIG_SYS_FLASH_ERASE_TOUT) {
chip1 = ERR | TMO;
break;
}
if (!chip1 && ((result & 0x80) == (data & 0x80)))
chip1 = READY;
} while (!chip1);
*addr = CMD_READ_ARRAY;
if (chip1 == ERR || *addr != data)
rc = ERR_PROG_ERROR;
if (iflag)
enable_interrupts ();
if (cflag)
icache_enable ();
return rc;
}
int write_buff (flash_info_t * info, uchar * src, ulong addr, ulong cnt)
{
ulong wp, data;
int rc;
if (addr & 1) {
printf ("unaligned destination not supported
");
return ERR_ALIGN;
}
#if 0
if (cnt & 1) {
printf ("odd transfer sizes not supported
");
return ERR_ALIGN;
}
#endif
wp = addr;
if (addr & 1) {
data = (*((volatile u8 *) addr) << 8) | *((volatile u8 *)
src);
if ((rc = write_word (info, wp - 1, data)) != 0) {
return (rc);
}
src += 1;
wp += 1;
cnt -= 1;
}
while (cnt >= 2) {
data = *((volatile u16 *) src);
if ((rc = write_word (info, wp, data)) != 0) {
return (rc);
}
src += 2;
wp += 2;
cnt -= 2;
}
if (cnt == 1) {
data = (*((volatile u8 *) src) << 8) |
*((volatile u8 *) (wp + 1));
if ((rc = write_word (info, wp, data)) != 0) {
return (rc);
}
src += 1;
wp += 1;
cnt -= 1;
}
return ERR_OK;
}
|