Blame view

kernel/linux-imx6_3.14.28/Documentation/sound/alsa/powersave.txt 1.93 KB
6b13f685e   김민수   BSP 최초 추가
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
  Notes on Power-Saving Mode
  ==========================
  
  AC97 and HD-audio drivers have the automatic power-saving mode.
  This feature is enabled via Kconfig CONFIG_SND_AC97_POWER_SAVE
  and CONFIG_SND_HDA_POWER_SAVE options, respectively.
  
  With the automatic power-saving, the driver turns off the codec power
  appropriately when no operation is required.  When no applications use
  the device and/or no analog loopback is set, the power disablement is
  done fully or partially.  It'll save a certain power consumption, thus
  good for laptops (even for desktops).
  
  The time-out for automatic power-off can be specified via power_save
  module option of snd-ac97-codec and snd-hda-intel modules.  Specify
  the time-out value in seconds.  0 means to disable the automatic
  power-saving.  The default value of timeout is given via
  CONFIG_SND_AC97_POWER_SAVE_DEFAULT and
  CONFIG_SND_HDA_POWER_SAVE_DEFAULT Kconfig options.  Setting this to 1
  (the minimum value) isn't recommended because many applications try to
  reopen the device frequently.  10 would be a good choice for normal
  operations.
  
  The power_save option is exported as writable.  This means you can
  adjust the value via sysfs on the fly.  For example, to turn on the
  automatic power-save mode with 10 seconds, write to
  /sys/modules/snd_ac97_codec/parameters/power_save (usually as root):
  
  	# echo 10 > /sys/modules/snd_ac97_codec/parameters/power_save
  
  
  Note that you might hear click noise/pop when changing the power
  state.  Also, it often takes certain time to wake up from the
  power-down to the active state.  These are often hardly to fix, so
  don't report extra bug reports unless you have a fix patch ;-)
  
  For HD-audio interface, there is another module option,
  power_save_controller.  This enables/disables the power-save mode of
  the controller side.  Setting this on may reduce a bit more power
  consumption, but might result in longer wake-up time and click noise.
  Try to turn it off when you experience such a thing too often.